Write-Protecting A Project - Zoom Handy Recorder H4 Operation Manual

4-Track Mode
2.
Move the jog dial up/down to bring
the cursor to the project you want to
delete. Then press the jog dial.
A confirmation message for the deletion appears.
DELETE button
3.
To proceed with the deletion, move
the jog dial up/down to bring the
cursor to the DELETE button, and
then press the jog dial.
The project is deleted, and the PROJECT menu
appears again. If the currently selected project
was deleted, the project with the lowest number
will be selected, and the display returns to the top
screen.
If you select the CANCEL button instead of the
OK button, the delete process is canceled, and
the DELETE menu appears again.
4.
To return to the PROJECT menu,
repeatedly press the center of the
[MENU] key.

Write-protecting a project

The currently selected project can be write-
protected. This will prevent the project from
being deleted, and no new recordings can be
made.
When a project is write-protected, the following
actions are not possible.
• Recording
• Deleting the project
• Deleting the file(s)
58
CANCEL button
• Changing file assignments
• Editing effect patches
HINT
Even when write-protect is enabled for a project,
you can perform playback as usual and change
the mixing balance etc. However, these changes
will not be stored.
1.
Refer to steps 1 – 3 of "Basic project
operations" and bring the cursor to
"PROTECT". Then press the jog dial.
The PROJECT PROTECT screen appears.
2.
Move the jog dial up/down to select
"ON" (protection enabled) or "OFF"
(protection disabled).
T h e c h a n g e d s e t t i n g b e c o m e s e f f e c t i v e
immediately.
When the setting is completed, press the center
of the [MENU] key to return to the 4-track mode
top screen. When protection is enabled, the
mark is shown to the left of the counter.
P mark
HINT
When you have completed a song, we
recommend to enable write-protect for the
project, to prevent unintended changes.
ZOOM H4