Zoom Handy Recorder H4 Operation Manual page 66

Effects
5.
Bring the cursor to the item you want
to edit ("PRE AMP" or "EFX") and
press the jog dial.
The effect module edit screen appears.
For example, if you have selected the "PRE
AMP" item, the following indication appears.
This screen allows effect module on/off selection
("ON/OFF"), effect type selection ("TYPE"), and
effect parameter control (other items).
6.
To change the effect type, proceed
as follows.
(1) Bring the cursor to the "TYPE" item and
press the jog dial.
The effect type can now be changed.
(2) Move the jog dial up/down to select the
effect type, and then press the jog dial.
The newly selected effect type becomes
active, and the effect parameter display
changes accordingly.
HINT
• To disable the effect module, bring the cursor
to "ON/OFF" (effect module on/off) and select
"OFF".
• For details about the types and parameters in
each effect module, see the reference section
at the end of this manual.
7.
To adjust the effect parameters,
proceed as follows.
66
(1) Bring the cursor to the target item (other
than "ON/OFF" and "TYPE"), and then
press the jog dial.
The selected item can now be changed.
If the parameters cannot be fully displayed on
one screen, you can move the cursor to scroll
the display and show other parameters.
The illustration below is an example for the
display shown when you move the cursor to
the "ZNR" item of the PREAMP module.
(2) Move the jog dial up/down to adjust the
value and then press the jog dial.
Parameter selection becomes possible again.
8.
To quit the editing screen for the
currently selected effect module,
press the center of the [MENU] key
once.
The EFFECT EDIT screen appears.
When the content patch has been changed, the
mark appears on the EFFECT EDIT screen.
If you return the changes to the original setting,
the icon disappears.
ED mark
9.
Repeat steps 5 – 8 as necessary to
edit the other module.
10.
To adjust the patch level, proceed as
follows.
ZOOM H4