Saving A Patch - Zoom Handy Recorder H4 Operation Manual

(1) On the EFFECT EDIT screen, bring the
cursor to the "LEVEL" item and press the
jog dial.
The patch level can now be edited.
(2) Move the jog dial up/down to change the
setting value, and then press the jog dial.
The parameter selection screen appears again.
11.
To close the EFFECT EDIT screen,
press the center of the [MENU] key.
If any setting was changed, a confirmation
message such as shown below appears.
12.
To save the changed settings, bring
the cursor to the STORE button, and
then press the jog dial.
The existing patch is overwritten and the
EFFECT menu appears again.
If you select the DON'T STORE button, the
settings are not stored and the EFFECT menu
appears again. If you select another patch in this
condition, the changes will be lost. You can also
select the CANCEL button to close the message
and cancel the store process. You can then
continue editing.
ZOOM H4
13.
To return to the 4-track mode top
screen, repeatedly press the center
of the [MENU] key.

Saving a patch

This section describes how to store the currently
selected patch in the same location (overwrite) or
in another location (copy).
1.
At the 4-track mode top screen,
press the bottom (INPUT MENU) of
the [MENU] key.
The INPUT menu appears.
2.
Bring the cursor to the "EFFECT"
item and press the jog dial.
The EFFECT menu appears. If required, select
the patch to be used as store source.
If the effect section is off, switch it to on. (The
screen below appears only when the effect
section is on.)
3.
Bring the cursor to the EDIT button
and press the jog dial.
The EFFECT EDIT screen appears.
Effects
67