Installing & Wiring The Receiver - Salus 091FLRF User Manual

GB
INTRODUCTION
This thermostat can replace most common residential thermostats
and is designed to be used with electric, gas or oil heating control
systems.
Unlike ordinary single unit design thermostats, this is a new type of
thermostat separating the operational functions into two units. The
Receiver serves for wiring connections and heat on/off control. The
Control Centre serves as user interface and temperature sensing/
control. The two units are linked by Radio Frequency.
The Receiver is easily installed using the Industry Standard back
plate supplied (for mounting purposes only as no wiring is required
when installing the control centre).
The back plate can be mounted directly to the wall surface.
Installing & Wiring the Receiver
Caution: Switch off the electric source before installing the receiver.
We recommend that the installation be performed by trained
personnel.
1) This must be 230V AC and fused at 13 amps max.
2) Select a suitable indoor location free from water and moisture.
3) The receiver should not be shielded from the RF signal in any way,
follow 'Testing the RF Transmission' section (PAGE 7
1