Emergency Call; Man Down Emergency Call; Scrambler Function; Priority A Channel Selection - Icom IC-F3022T Instruction Manual

3
BASIC OPERATION

■ Emergency Call

The emergency call can be performed with [Emergency] (p. 7).
The transceiver will send a 5-tone, DTMF or MDC 1200
emergency signal* one time only or repeatedly on the emer-
gency channel. However, when no emergency channel is
specified, the signal is transmitted on the previously selected
channel.
If you want to cancel the emergency call, push and hold the
key again before transmitting the call.
* Depending on the operating model type.

■ Man Down Emergency Call

This function requires the optional UT-124R
and can be performed in conventional mode.
The man down emergency call function transmits an emer-
gency call automatically when the transceiver has been left
in a horizontal position.
After the emergency call, the transceiver performs transmis-
sion and reception alternately with receiving a signal and
emitting audio.
When the emergency reset signal is received, the function is
cancelled.
IMPORTANT: Set an emergency channel individually, to
provide certain emergency call operation is recommended.
14

■ Scrambler function

The voice scrambler function provides private communica-
tion between stations. The optional Rolling or Non-rolling
type can be available.
q Push [Scrambler] to turn the scrambler function ON.
• " " appears.
w Push [Scrambler] again to turn the scrambler function
OFF.
• " " disappears.

■ Priority A channel selection

When one of the following operations is performed, the
transceiver selects the Priority A channel automatically.
man down unit
Priority A is selected when;
• Clear down signal is received/transmitted
- Set the 'Move to PrioA CH' item as 'Clear down.'
• Turning the power ON
The Priority A channel is selected each time the trans-
ceiver power is turned ON.
• Status call
The Priority A channel is selected when transmitting a
status call.