Operation; Turning Power On; Channel Selection - Icom IC-F111 Instruction Manual

2

OPERATION

■ Turning power ON

q Push [ ] to turn the power ON.
w If the transceiver is programmed for a start up passcode,
input the digit codes as directed by your dealer.
• The keys in the table below can be used for password input.
• The transceiver detects numbers in the same block as identi-
cal. Therefore "01234" and "56789" are same.
KEY
NUMBER
e When the "PASSWORD" indication does not clear after in-
putting 4 digits, the input code number is incorrect. In this
case, turn the power off and start over.
7
0 1 2 3
5 6 7 8

■ Channel selection

Several types of channel selection are available. The meth-
ods may differ according to your system setup.
NON-BANK TYPE:
Push [ ]/[ ] to select the desired operating channel in se-
quence; or, push one of the [CH 1] to [CH 4] keys to select a
channel directly.
BANK-TYPE:
4
Push [BANK] to select the desired bank number or name.
9
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
the power ON, the transceiver automatically starts scanning.
Scanning stops when receiving a call or when taking the mi-
crophone off hook.