Step 5 - Wiring The Fan - Hunter Fans Installation And Operation Manual

STEP 5 - WIRING THE FAN

1. Disconnect the power by turning
off the circuit breakers to the out-
let box and associated wall switch
location.
2. Being careful not to scratch the
canopy finish, tilt and hang the
assembled fan from the ceiling
plate hook using one of the two
(2) slots in the canopy. See Fig-
ure 5a.
3. You can use either one or two
wall switches to control the fan
and/or lights separately. Use con-
nection 1 on page 14 to:
41557-01 3/12/2002
• control the light with a wall
switch and the fan with a
chain pull (one wall switch re-
quired)
• control the light with a chain
pull and the fan with a wall
switch (one wall switch re-
quired)
• control the light with one wall
switch and the fan with an-
other (two wall switches re-
quired)
Use connection 2 on page 14 if
there is no separate wall switch
power wire for the light fixture.
Note: Wall switches not included.
Ceiling
Plate
Hook
Figure 5a - Assembled Fan Hanging from
Ceiling Plate Hook
®
Ceiling
Plate
continued
13