Step 6 - Hanging The Fan - Hunter Fans Installation And Operation Manual

STEP 6 - HANGING THE FAN

1. Locate the two canopy screws
you partially installed in Step 2,
sub-step 2 on page 8.
2. Lift the fan from the ceiling plate
hook without breaking the wire
connections.
3. Align the mounting slots on the
canopy with the mounting screws
Ceiling Gasket
Ceiling Plate
(2) Canopy
Mounting Screws
Mounting Hole
Canopy
(2) Mounting
Slots
Figure 6a - Attaching Canopy to Ceiling
Plate
41557-01 3/12/2002
on the ceiling plate. Lift the
canopy into place so that the ceil-
ing gasket covers the top of the
canopy as shown in Figure 6a.
Rotate the canopy until it drops
into place on the mounting
screws.
4. Install and tighten the third
canopy mounting screw in the
remaining hole by lifting the edge
of the gasket cover. Tighten the
first two canopy mounting
screws.
5. Lift the fan housing towards the
ceiling and rotate the fan until
each canopy tab engages a
groove in the hanger ball as
shown in Figure 6b.
NOTE: If the tabs are already
engaged, do not rotate.
WARNING
Failure to complete sub-steps
1 through 5 could cause fan to
fall.
Groove in
Hanger Ball
Groove in
Hanger
Ball
Canopy
Tab
Figure 6b - Canopy Tabs and Grooves in
Hanger Ball
®
15