Hunter Fans Installation And Operation Manual page 14

®
4. Connect the wires as shown in
Figure 5b. To connect the wires,
twist the bare metal leads to-
gether. Place a wire nut over the
intertwined length of wire and
twist clockwise until tight as
shown.
CAUTION
Be sure no bare wire or wire
strands are visible after mak-
ing connections.
5. Separate the connected wires by
placing the green and white wires
on one side of the outlet box and
the black and the black/white
wires on the other side of the
outlet box.
6. Turn the connectors upward. Push
the wires gently into the outlet
box.
14
Wall Switch Wire For
Separate Control of Light Fixture
Black
Power
Wires
In
White
Ceiling
Bare or Green
2 x 4 Brace
Green
Approved
Connectors
Green Ground
Wire from Hanger
Pipe (not present
with flush mounting
option)
Figure 5b - Wiring Diagram
(Note: Wall switch
must be acceptable
as a general-use
switch.)
Outlet Box
Ceiling
Plate
1
2
Connections:
1 Connect Blk/Wht Wire from fan
to Wall Switch Wire for separate
Black/White
control of light fixture, or
Connect Blk/Wht Wire from fan
2
3 Wires to Ceiling Black Wire if there
From Fan
is no separate Wall Switch Wire
for the light fixture.
41557-01 3/12/2002