Honda Marine BF200A Owner's Manual page 91

6. Reinstall the fuse cover and the
engine cover.
7. Reconnect the battery.
Never use a f use with a rating
greater than specif ied. Serious
damage to the electrical system could
result.
If a blown fuse is found, try to
determine and correct the electrical
problem that caused the blown fuse.
An uncorrected electrical problem
may cause the fuse to blow again.
If fuses continue to blow, take the
outboard motor to an authorized
Honda marine dealer for inspection
and service or refer to the shop
manual.
TAKING CARE OF UNEXPECTED PROBLEMS
ACG Fuse
''150 A''MARK
FUSE (150 A)
FUSE CASE LID
SPARE FUSE
Disconnect the battery cable at the
battery negative (-) terminal bef ore
replacing the f use.
Failure to do so may cause a short
circuit.
Replacement
1. Stop the engine.
2. Disconnect the battery.
3. Remove the engine cover.
4. Remove the fuse case lid.
5. Remove the old fuse by removing
two 5 mm screws.
6. Install a new fuse with the ''150
A'' mark downward.
ACG FUSE: 150 A
7. After finishing replacement, install
the fuse case lid with its hook
toward the engine side.
8. Be sure to check the fuse case lid
is securely locked.
9. Install the engine cover.
10. Reconnect the battery.
A spare fuse is located on the reverse
side of the fuse case lid and tightened
with two 3 mm screws.
When the new fuse is set as a spare
fuse on the reverse side of the fuse
case lid, set the fuse so that you can
see the ''150 A'' mark on it.
89