Honda Marine BF200A Owner's Manual page 73

ENGINE OIL FILTER
FUEL FILTER (inside strainer cup)
2. Looking through the translucent
strainer cup, check the fuel filter
for water accumulation or
sediment.
SERVICING YOUR OUTBOARD MOTOR
SCREW (3)
FUEL HOSES
SUSPENSION STRAP
3. Remove the suspension strap from
the strainer bracket, then remove
the strainer assembly from the
strap.
Before removing the fuel filter, to
prevent fuel leakage, place fuel
hose clamps on the fuel hoses on
each side of the fuel filter.
4. Remove the three screws and
separate the fuel strainer cup from
the strainer body.
5. Thoroughly clean the strainer cup,
and replace with a new fuel filter.
6. Reassemble the strainer body and
the cup.
STRAINER TIGHTENING
TORQUE:
3.4 N·m (0.35 kgf·m , 2.5 lbf·ft)
7. Install the suspension strap to the
fuel strainer.
'' ''
8. Align the I mark on the
suspension strap as shown below
and install the fuel strainer to the
bracket.
FUEL STRAINER
SUSPENSION STRAP ''I'' MARK
71