Uptime Command - Qlogic SANbox 1400 Series Installation Manual

B – Command Line Interface

Uptime Command

Uptime Command
Displays the elapsed up time since the switch was last reset and reset method. A
hot reset or non-disruptive firmware activation does not reset the elapsed up time
reported by this command.
Authority
None
Syntax
uptime
Examples
The following is an example of the Uptime command:
SANbox #> uptime
Elapsed up time
Reason last reset: NormalReset
B-94
: 0 day(s), 2 hour(s), 28 min(s), 44 sec(s)
S
59225-00 B