Qlogic SANbox 1400 Series Installation Manual page 196

B – Command Line Interface
Zoning Command
save
Saves changes made during the current Zoning Edit session. The system will
inform you that the zone set must be activated to implement any changes. This
does not apply if you entered the Zoning Clear command during the Zoning Edit
session.
Examples
The following is an example of the Zoning Edit command:
SANbox #> admin start
SANbox (admin) #> zoning edit
SANbox (admin-zoning) #>
.
.
SANbox (admin-zoning) #> zoning cancel
Zoning edit mode will be canceled.
SANbox (admin) #> admin end
B-108
Please confirm (y/n): [n]
S
y
59225-00 B