Set Config Port Parameters - Qlogic SANbox 1400 Series Installation Manual

A
LinkSpeed
PortType
SymbolicPortName
ALFairness
DeviceScanEnabled
ForceOfflineRSCN
ARB_FF
InteropCredit
ExtCredit
FANEnable
59225-00 B
Table B-9. Set Config Port Parameters (Continued)
Parameter
Transmission speed: 1-Gbps, 2-Gbps, 4-Gbps, or Auto.
The default is Auto.
Port type: GL, G, F, FL, Donor. The default is GL.
Descriptive name for the port. The name can be up to 32
characters excluding #, semicolon (;), and comma (,).
The default is Port n where n is the port number.
Arbitration loop fairness. Enables (True) or disables
(False) the switch's priority to arbitrate on the loop. The
default is False.
Enables (True) or disables (False) the scanning of the
connected device for FC-4 descriptor information during
login. The default is True.
Enables (False) or disables (True) the immediate trans-
mission of RSCN messages when communication
between a port and a device is interrupted. If enabled,
the RSCN message is delayed for 200 ms for locally
attached devices and 400 ms for devices connected
through other switches. The default is False. This param-
eter is ignored if IOStreamGuard is enabled.
Send ARB_FF (True) instead of IDLEs (False) on the
loop. The default is False.
Interoperability credit. The number of buffer-to-buffer
credits per port. 0 means the default (8) is unchanged.
Changing interoperability credits is necessary only for
E_Ports that are connected to non-FC-SW-2-compliant
switches. Contact your authorized maintenance provider
for assistance in using this feature.
Extended credits. The number of port buffer credits that
this port can acquire from donor ports. The default is 0.
Fabric address notification. Enables (True) or disables
(False) the communication of the FL_Port address, port
name, and node name to the logged-in NL_Port. The
default is True.
B – Command Line Interface
Set Config Command
Description
B-41