Window Installation (On Some Models) - Whirlpool ACE082PT1 Use & Care Manual

3. Pull o ffthecontrol knobs ( onsome models).
4. Remove thetwoscrews f rom thefrontpanel.
5. Remove the front panel from the air conditioner and set
aside.
6. Remove the ground screw and ground wire from the front of
the air conditioner base. Save the ground screw.
7. Pull on the handle to slide the air conditioner out of the
cabinet. Place the air conditioner on cardboard.
A. Handle
NOTE: Do not lift, push, pull or remove any expanded
polystyrene (foam) from inside the air conditioner. It is not
packing material.
'_ .............. B
A. Green ground wire
B. Ground screw
NOTES:
• Handle the air conditioner gently.
3. Using 3 - #10 x %" washer-head Phillips screws, attach the
top channel to the air conditioner cabinet.
Be sure your air conditioner cabinet does not fall out of the
opening during installation or removal,
The location where the power cord exits the air conditioner
should be no more than 4 ft (122 cm) from a grounded
3 prong outlet.
Do not block the louvers on the front panel.
Do not block the louvers on the outside of the air conditioner.
Attach Top Channel
NOTE: Attach the top channel and the side curtains to the air
conditioner cabinet before placing the cabinet in the window.
1. Locate the bag of screws provided.
2. Place the top channel on top of the air conditioner cabinet,
lining up the 3 holes in the top channel with the 3 holes on top
of the air conditioner cabinet.
B A B B
?
A. Top channel
B. #10 x _" washer-head Phillips screws (3)