Air Conditioner Use; Starting Your Air Conditioner-- Digital Control - Whirlpool ACE082PT1 Use & Care Manual

AIR CONDITIONER USE
Operating your air conditioner properly helps you to obtain the
best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
• If you turn off the air conditioner, wait at least 3 minutes
before turning it back on. This prevents the air conditioner
from blowing a fuse or tripping a circuit breaker.
Do not try to operate your air conditioner in the cooling mode
when outside temperature is below 65°F (18°C). The inside
evaporator coil will freeze up, and the air conditioner will not
operate properly.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
f
0 Turbo0
TIMER FAN SPEED Low 0
_ Auto 0
MODE Cool FanOnly PowerSaver
-% 2. Choose Cool, Fan Only or Power Saver.
• Cool--Cools room. Press FAN SPEED to choose fan
speed. Press the up or down arrow buttons to adjust the
temperature.
• Fan--Operates the fan at Turbo speed, without cooling.
The display shows "FO" (fan only).
TEMP • Power Saver--Fan runs only when cooling is needed. You
can select the fan speed by pressing Fan Speed.
Because the fan does not circulate the room air
continuously, less energy is used, but the room air is not
O_ circulated as often. Use Power Saver when you are
%,_/ o,FILTER
........
asleep or away from home.
© o
MOD£ Powel S aver
J
NOTES:
• When the air conditioner is off, the display shows the current
room temperature.
• If the room temperature is below 55°F (13°C), the display will
show 55°F (13°C). If the room temperature is above 99°F
(37°C), the display will show 99°F (37°C).
1. Remove clear protective film from control panel and front
panel badge (on some models).
2. Press POWER to turn on the air conditioner.
NOTE: When air conditioner is turned on for the first time
after it is plugged in, it will display the default settings: Cool
mode, Turbo fan speed, 72°F (22°C) for 3 seconds. When it is
turned on at all other times, it will display the previous
settings for 3 seconds, and then display the room
temperature.
3. Select mode. See "Mode."
4. Select fan speed. See "Fan Speed."
5. Set temperature. See "Temperature."
Mode
Fan Speed
NOTE: The Fan Speed button will operate only when the Cool or
Power Saver mode has been selected.
1. Press and hold FAN SPEED until you see the indicator light
come on for the setting you desire.
2. Choose Turbo, High, Low or Auto.
Turb00
@ @0
FAN SPEED
LowO
Aut0 0
Filter Monitor
1. When filter indicator light is lit or flashing, remove, clean and
replace air filter. See "Cleaning the Air Filter."
2. Press and hold FILTER for 3 seconds after cleaning and
replacing the air filter. This resets the filter monitor.
O@ FILTER
NOTE: After 360 hours of fan operating time, the filter indicator
light will turn on. It will remain on for 180 hours or until you press
FILTER. After 180 hours, it will flash. It will continue flashing until
you press FILTER.
1. Press and hold MODE until you see the indicator light for the
desired setting.
11