Using The Remote Control - Whirlpool ACE082PT1 Use & Care Manual

Temperature
• Press the plus button to raise the temperature. Each time you
press or hold the plus button, the temperature will go up 1° to
a maximum temperature of 86°F (30°C).
NOTE: After 3 seconds, display will show the current room
temperature.
\
TEMP
V
• Press the minus button to lower the temperature. Each time
you press or hold the minus button, the temperature will go
down 1° to a minimum temperature of 64°F (18°C).
NOTE: After 3 seconds, display will show the current room
temperature.
Timer Delay
To set the Timer to turn off the air conditioner (the air
conditioner must be On}:
1. Press TIMER. Timer indicator light will flash. Display will show
remaining hours before the air conditioner will turn off.
O
®
TIMER
2. Press the plus or minus button to adjust the delay time from
1 to 24 hours.
3. Press TIMER again or wait 10 seconds. Timer indicator light
will remain on. Display will show the current room
temperature.
To set the Timer to turn on the air conditioner, keeping
previous settings:
1. Turn off the air conditioner.
2. PressTIMER. Timer indicator light will flash. Display will show
remaining hours before the air conditioner will turn on.
3. Press the plus or minus button to change delay time from 1 to
24 hours.
4. Press TIMER again or wait 10 seconds. Timer indicator light
will remain on. Display will show current room temperature.
To set the Timer to turn on the air conditioner, changing
previous settings:
1. Turn on the air conditioner.
2. Adjust the mode to Cool, Fan Only, or Power Saver.
3. Adjust the fan speed to Turbo, High, Low or Auto.
4. Adjust temperature between 64°F and 86°F (18°C and 30°C).
5. Turn off the air conditioner.
6. Press TIMER. Timer indicator light will flash. Display will show
remaining hours before the air conditioner will turn on.
7. Press the plus or minus button to change delay time from 1 to
24 hours.
8. Press TIMER again or wait 10 seconds. Timer indicator light
will remain on. Display will show current room temperature.
To clear Timer delay program:
NOTE: Air conditioner can be either on or off.
Press and hold TIMER for 3 seconds. Timer indicator light will
shut off.
To see or change the remaining time (in hours):
1. Press TIMER once after it has been programmed. Display will
show remaining time.
2. While the display is showing the remaining time, you can
press the plus or minus button to increase or decrease the
time.
3. After 10 seconds, display will show the current room
temperature.
NOTE: Remote control may vary in appearance. NOTE: Two AAA batteries (included) power the remote control.
Replace batteries after 6 months of use, or when the remote
control starts to lose power.
To Turn the Air Conditioner On or Off
Press POWER.
To Select the Mode
Press COOL, FAN, or POWER SAVER.
To Select the Fan Speed
Press FAN SPEED for Turbo, High or Low or Auto.
NOTE: Auto fan speed cannot be selected in Fan Only mode.
12