Other Connectors - Foxconn 865A01 series User Manual

Other Connectors

This motherboard includes interfaces for FDD, IDE HDD, SATA, USB, 1394,
IR module, CPU/system fan, and others.
FDD
This motherboard includes a standard FDD interface, supporting 360K, 720K,
1.2M, 1.44M, and 2.88M FDDs.
HDD connectors: PIDE & SIDE
These connectors support the provided UltraDMA 100/66/33 IDE hard disk
r i b b o n c a b l e . C o n n e c t t h e c a b l e ' s b l u e c o n n e c t o r t o t h e p r i m a r y
(recommended) or secondary IDE connector, then connect the gray connec-
tor to the Ultra DMA 100/66/33 slave device (hard disk drive) and the black
connector to the Ultra DMA 100/66/33 master device. If you install two hard
disks, you must configure the second drive as a slave device by setting its
jumper accordingly. Refer to the hard disk documentation for the jumper
settings.
Attention:
Ribbon cables are directional, therefore, make sure to always
connect with the cable on the same side as pin 1 of the PIDE/
SIDE or FDD connector on the motherboard.
24
865A01-FOXCONN-V1.3-EN-121603.p65
Chapter 2 Installation Instructions
865A01 G/PE User Manual
24
FDD Interface
2004-5-27, 18:02