Other Connectors - Foxconn P9657AB User's Manual

Other Connectors

This motherboard includes connectors for FDD devices, IDE devices, Serial ATA
devices, USB devices, IR module, and others.
FDD Connector: FLOPPY
This motherboard includes a standard FDD connector, supporting 360K, 720K,
1.2M, 1.44M, and 2.88M FDDs.
IDE Connector: PIDE
The PIDE connector supports Ultra DMA 100/66 IDE hard disk drives.
Connect the cable's blue connector to the IDE connector, then connect the gray
connector to the slave device (hard disk drive) and the black connector to the
Ultra ATA master device. If you install two hard disks, you must configure the
second drive as a slave device by setting its jumper accordingly. Refer to the hard
disk documentation for the jumper settings.
Attention:
Ribbon cables are directional, therefore, make sure to always connect with
the cable on the same side as pin1 of the PIDE/RIDE or FLOPPY connector
on the motherboard.
Audio Connector: F_AUDIO
The audio connector supports HD au-
dio standard. It provides two kinds of
audio output choices: the Front Audio,
the Rear Audio. Front Audio supports
re-tasking function.
Audio Connectors: CD_IN
CD_IN is Sony standard CD audio connectors,
it can be connected to a CD-ROM drive through
a CD audio cable.
Chapter 2 Installation Instructions
1
PORT1_L
PORT1_R
PORT2_R
SENSE_SEND
PORT2_L
9
F_AUDIO (HDA)
1
CD_IN
2
AUD_GND
PRESENCEJ
SENSE1_RETURN
Empty
SENSE2_RETURN
10
CD_R
GND
CD_L
13