Foxconn 865A01 series User Manual page 64

POWER On Function (Default: BUTTON ONLY)
This option is used to set the power on method for your PC. Setting values
include: Button Only, Password, Hot-key, Mouse Left, Mouse Right, Any Key
and Keyboard 98 (keyboard is consistent with Windows 98 Standard).
KB Power ON Password (Default: Enter)
This option is used to set the PC Startup with Keyboard function. You will
be prompted to enter the password after pressing the <Enter> key.
Note: This function will only work when the Power On function is set to
Password, or you can not change it.
Hot Key Power ON (Default: Ctrl-F1)
This option is used to set which hot keys will be used for the Power On
Function (when it is set to Hot Key for Startup). The available setting values
are: Ctrl+F1-F12.
Onboard FDC Controller (Default: Enabled)
This option is used to set whether the Onboard FDC Controller is enabled.
The available setting values are: Disabled and Enabled.
Onboard Serial Port 1/2 (Default: 3F8/IRQ4/2F8/IRQ3)
This option is used to set the signal requested for address and
interruption for the Onboard Serial Port 1/2. Setting values include 2F8/
IRQ3, 3F8/IRQ4, 3E8/IRQ4, 2E8/IRQ3, Auto and Disabled.
Note: Do not try to set the same values for serial ports 1 and 2.
UART Mode Select (Default: Normal)
Use this option to select the UART mode. Setting values include Normal,
IrDA, and ASKIR. The setting value is determined by the infrared module
installed on the board. When it is set to IrDA and ASKIR, the UART supports
communication with the MB by means of the infrared module; when it is set
to Normal, the infrared function is unavailable.
56
865A01-FOXCONN-V1.3-EN-121603.p65
Chapter 3 BIOS Description
Super IO Configuration Setup Menu
865A01 G/PE User Manual
56 2004-5-27, 18:02