Table of Contents
Advertisement
Action
1. Connect the RED and BLACK test leads to the RED and BLACK test jacks on the
ESA601.
2. Position the
3. Connect the RED test lead to the DUT enclosure; connect the DUT power cord to the
test receptacle on the ESA601.
4. Connect the BLACK test lead to the protective earth or any other test point.
5. After the meter settles, read the display (voltage between the RED and BLACK test
leads), and/or press the
6. Repeat steps 4 and 5 for any other exposed conductive part of the DUT.
The followings steps can be performed if desired.
7. Set the
NEUTRAL SWITCH
8. After the meter settles, read the display, and/or press the
reading.
9. Set the
NEUTRAL SWITCH
10. Set the
EARTH SWITCH
11. After the meter settles, read the display, and/or press the
reading.
12. Set the
EARTH SWITCH
13. Set the
POLARITY SWITCH
to illuminate.
14. Repeat steps 7 through 12.
-
FUNCTION
SELECTION KNOB
PRINT SWITCH
Note
to
.
OPEN
to
CLOSED
to
.
OPEN
to
.
CLOSED
to
REVERSE
Performing Electrical-Safety Tests
to
DUAL LEAD VOLTAGE
to print the reading.
PRINT SWITCH
.
PRINT SWITCH
, and wait for the
REVERSE POLARITY
Local Control
.
to print the
to print the
indicator
5
5-31
Hide quick links:
Advertisement
Table of Contents
