Powering Up The Esa601; Support - Fluke ESA601 Operator's Manual

Powering Up the ESA601

For the location of the
the
POWER SWITCH
items 10, 17, and 18, and the accompanying descriptions of switches and indicators on
the unit's right-side and top panels.
With the controls identified, perform the following steps to power up the ESA601.
1. Turn the
2. Power up the system by toggling the
three seconds the unit powers up, and a green light appears in the
indicate the tester is switched on.
3. When the unit is powered up, the ESA601 will check for proper polarity and
range of the AC-input voltage. During this check, the display indicates firmware
X.XX (e.g. 1.00). If all goes well during power up, the display will show the
word
OFF
4. If the
FUNCTION
the unit immediately moves (with audible clicking) to the mode indicated by the
current
related to that selected function (usually a meter reading).
5. If a fault is found at startup, a RED light appears in the
the ESA601 display indicates an error code. (For explanations of startup-error
codes, see the section called "Error Codes" in Chapter 7 of this manual.
Once you have the ESA601 up and running, please fill out the Registration
Card and mail it to Fluke Biomedical.

Support

After power-up and connection, if the new ESA601 system fails to start or to operate
successfully, please contact Fluke Biomedical immediately. The Technical Assistance
Center is open between 8:00 AM and 5:00 PM, Pacific Standard Time, Monday through
Friday, except holidays.
Contact Fluke Biomedical in the following ways:
When contacting the Technical Assistance Center, please provide the following
information:
1. ESA601 version and serial number.
2. Specific steps necessary to reproduce the problem.
3. A phone number where you can be contacted during the day.
-
FUNCTION SELECTION KNOB
, refered to Figure 1-1 in Chapter 1 of this manual. Specifically locate
-
FUNCTION SELECTION KNOB
.
-
SELECTION KNOB
-
FUNCTION SELECTION KNOB
Note
(800) 648-7952 (in the U.S.) or (775) 883-3400
Fluke Biomedical
5200 Convair Drive
Carson City, NV 89706-0403
techservices@flukebiomedical.com
sales@flukebiomedical.com
, the -
POWER STATUS INDICATORS
to the position.
OFF
to the
POWER SWITCH
is not set to when the unit is powered up,
OFF
setting, and the display indicates a reading
POWER FAULT LED
Setting Up the ESA601
Powering Up the ESA601
, and
position. After
ON
to
POWER LED
, and
2
2-3