Management Module Leds - Extreme Networks BlackDiamond X8 Series Hardware Installation Manual

Chapter 2: BlackDiamond X8 Series Modules and Fans

Management Module LEDs

LEDs on the management module
and major chassis components.
Table 4: LEDs on the BDX-MM1 Management Module
Label/Function
ERR
Error
ENV
Environmental status
MSTR
Master/backup status
of module
SYS
System status
FAN
General fan status
FM
Fabric module status
Link
(on Management port)
Activity
(on Management port)
Auxiliary port
(unlabeled)
20
(Table 4) provide status information about operation of the switch
Color/State Meaning
Amber/steady A critical software error has been logged since power-up.
Off Normal operation is occurring.
Green/steady The system is operating within the defined operational limits.
Amber/steady The system is operating outside the defined operational limits.
Green/steady This management module is the master in the system.
Green/blinking Power-on self-test (POST) is running.
Amber/steady Module is operating as backup (secondary) MM.
Off Normal operation for diagnostics.
Green/blinking The system has booted and is operating normally.
Amber/blinking Diagnostic tests are running on the module.
The LED resets if the diagnostics are terminated. The LED returns
to flashing amber if another diagnostic test is started.
Amber/steady Diagnostic failure has occurred.
Off The switch is not receiving power.
Amber/steady A fan failure has occurred. Check the Fan LEDS on the fan trays
at the rear of the chassis. (See
Off Fans are operating normally.
Amber/steady The fabric module is running diagnostics or has a fault condition.
Check the FM LEDs on the fan trays at the rear of the chassis.
(See Table 6 on page
Off All the fabric modules are operating normally.
Green Link is up.
Off Link is down.
Amber Packet activity is occurring.
Off No packet activity is occurring.
N/A For future development
BlackDiamond X8 Series Switches Hardware Installation Guide
Table 7 on page
25.)
26.)