Installing A Management Module Blank - Extreme Networks BlackDiamond X8 Series Hardware Installation Manual

Replacing a Management Module
Figure 52: Locking the Module into Place

Installing a Management Module Blank

If a management module is not installed in a slot, you must install a blank cover over the slot to
maintain proper EMI levels and ventilation to ensure conformance to FCC requirements as well as to
maintain adequate airflow through the switch.
To install a management module blank:
1 Set the blank in place over the open slot.
2 Align and tighten the captive retaining screws.
BlackDiamond X8 Series Switches Hardware Installation Guide
85