Extreme Networks BlackDiamond X8 Series Hardware Installation Manual page 83

3 On the injector/ejector lever, turn the captive screw counter-clockwise until the yellow band around
the screw head of is completely visible
Figure 49: Unlocking a Module
4 Squeeze the release latch on the injector/ejector handle and rotate the handle to the right (away from
the module) to unseat the module from the internal connectors
Figure 50: Removing a Management Module
5 Slide the module out of the chassis slot.
Immediately place the module into an anti-static bag to protect it from potential ESD damage. The
bag will also prevent dust from collecting on the module connectors.
6 If you are not going to install a replacement module, install a blank front panel as described in
"Installing a Management Module Blank" on page
BlackDiamond X8 Series Switches Hardware Installation Guide
(Figure 49).
85.
Replacing a Management Module
(Figure 50).
83