Extreme Networks BlackDiamond X8 Series Hardware Installation Manual page 66

Chapter 6: Installing BlackDiamond X8 Series Modules
4 Verify that the module injector/ejector handles are open
Keep the injector/ejector handles in the open position as you slide the module into the chassis slot.
NOTE
If the injector/ejector handles are in the latched position, they prevent the module from sliding all the way
into the slot.
Figure 34: Installing an I/O Module
5 Carefully slide the module into the slot until the injector/ejector handles engage the edges of the
chassis and begin to rotate toward the center of the module.
6 Push the handles toward each other to seat the module internal connectors
66
(Figure 34).
BlackDiamond X8 Series Switches Hardware Installation Guide
(Figure 34).