Performing The First-Time Setup Of The Summit Wm Controller; Accessing The Summit Wm Controller - Extreme Networks Summit WM20 User Manual

For more information, see
Step 7 – Confirming the AP firmware version
Confirm the latest firmware version is loaded. For more information, see
Software Maintenance" on page
Performing the First-Time Setup of the Summit WM
Controller
Before you can connect the Summit WM Controller to the enterprise network, you must change the IP
address of the Summit WM Controller management port from its factory default to the IP address
suitable for your enterprise network. Access the Summit WM Controller by one of two methods:
Use the method described in
●
Summit WM20 Controller console. Use the Command Line Interface (CLI) commands. For more
information, see the Summit WM20 CLI Reference Guide.
Use a laptop computer with a Web browser. Connect the supplied cross-over Ethernet cable between
●
the laptop and management Ethernet port of the Summit WM Controller. Follow the steps below.

Accessing the Summit WM Controller

1 Statically assign an unused IP address in the 192.168.10.0/24 subnet for the Ethernet port of the
computer. For example, 192.168.10.205.
2 Launch your Web browser (Internet Explorer version 6.0 or higher, or FireFox).
3 In the browser address bar, type the following:
https://192.168.10.1:5825
This launches the Summit WM GUI. The logon screen is displayed.
Summit WM20 User Guide, Software Release 4.2

Performing the First-Time Setup of the Summit WM Controller

Chapter 3, "Configuring the Wireless AP."
81.
"Console Port for Summit WM20 Controller" on page 238
"Performing Wireless AP
to access
37