Connect Power - Extreme Networks BlackDiamond X8 Series Hardware Installation Manual

c Align and tighten the retaining screws.
Caution
Do not operate the switch without the power supply cover in place. This cover is
required to maintain proper EMI levels for the switch.
Figure 27: Installing the Power Supply Ventilation Cover

Connect Power

Use this procedure to connect the AC power cords and the cord retainer.
1 At the back of the chassis, connect an AC power cord to the power input socket that corresponds to
each installed power supply.
Power input sockets are numbered from 1A to 8B from left to right, as you face the chassis back.
Figure 28: Numbers for Power Connectors
2 After all the power cords have been connected, set the power cord retainer over the power cord
connectors and against the back of the chassis.
BlackDiamond X8 Series Switches Hardware Installation Manual
Installing a BlackDiamond X8 Series Chassis
48