Extreme Networks BlackDiamond X8 Series Hardware Installation Manual page 47

4 Slide the power supply into the chassis until the lever starts to engage.
Figure 26: Installing a Power Supply
5 Rotate the lever toward the front of the power supply to fully seat the power supply in the chassis.
6 Repeat steps to install other power supplies as required by your system configuration.
7 Replace the power supply ventilation cover.
a Set the lower edge of the cover in place so that the tabs on the edge fit into the matching slots
in the chassis frame.
b Rotate the top of the cover into place against the front of the chassis frame.
BlackDiamond X8 Series Switches Hardware Installation Manual
Installing a BlackDiamond X8 Series Chassis
47