Extreme Networks BlackDiamond X8 Series Hardware Installation Manual page 75

1 Holding the module by the metal rail and front panel only, remove the module from the antistatic
packaging.
Caution
To prevent ESD damage, never touch the components on the PCB or the pins on any of
the connectors.
2 Verify that the injector/ejector handle is in the open position.
Keep the injector/ejector handle in the open position as you slide the module into the chassis slot.
3 Carefully slide the module into the slot until the injector/ejector handle engages the edge of the
chassis and begins to rotate toward the module.
4 Use the lever to fully seat the internal module connectors.
Figure 53: Installing a Management Module
BlackDiamond X8 Series Switches Hardware Installation Manual
BlackDiamond X8 Maintenance Procedures
75