Reseating A Management Module Dimm - Extreme Networks BlackDiamond X8 Series Hardware Installation Manual

2 Align the module blank with the card guides for the open slot on the chassis.
Figure 59: Installing a Module Blank
3 Use a #2 Phillips screwdriver to tighten the captive screws at each end of the module blank.
a Tighten the screws of each installed module blank before inserting additional modules or blanks.
Otherwise, you might unseat modules or blank front panels that you have not secured.

Reseating a management module DIMM

If you need to reseat the DIMM, perform the following procedure:
1 Attach the ESD-preventive wrist strap to your bare wrist. If it is not already connected, connect the
metal end to the receptacle between the management module slots.
2 Disconnect network cables from the front of the module.
BlackDiamond X8 Series Switches Hardware Installation Manual
BlackDiamond X8 Maintenance Procedures
81