Initial Management Access - Extreme Networks BlackDiamond X8 Series Hardware Installation Manual

2 Align the module blank with the card guides for the open slot on the chassis.
Figure 38: Installing a Module Blank
3 Use a #2 Phillips screwdriver to tighten the captive screws at each end of the module blank.Tighten
the screws of each installed module blank before inserting additional modules or blanks. Otherwise,
you might unseat modules or blank front panels that you have not secured

Initial Management Access

After your switch has completed all power on self-tests, it is operational.
You can log in and configure an IP address for the default VLAN (named default).
Note
In BlackDiamond switches, the management port on the MM is part of the management
VLAN by default. Refer to
Console Port Settings
Connection to the console port is used for direct local management.
BlackDiamond X8 Series Switches Hardware Installation Manual
Installing BlackDiamond X8 Series Modules
Management Ports for further details.
59