Troubleshooting
the Rider
PROBLEM
LOOK FOR
REMEDY
Ground speed levers not in
Lock ground speed levers in START/PARK
positions.
START/PARK positions.
PTO (electric clutch) switch
Place in OFF position.
in ON position.
Out of fuel.
If engine is hot, allow it to cool, then refill the fuel tank.
Parking brake disengaged.
Engage parking brake.
Fuel valve closed (if
Open fuel valve.
equipped).
Engine flooded.
Open the choke.
Gas is old or stale.
Drain fuel and replace with fresh fuel.
Engine witl not turnover
Battery terminals require
Clean the battery terminals.
or start,
cleaning.
Battery discharged or dead.
Recharge or replace.
Wiring loose or broken.
See authorized service dealer.
Solenoid or starter motor
See authorized service dealer.
faulty.
Safety interlock switch not
See authorized service dealer.
working.
Spark plug(s) faulty, fouled
Clean and gap or replace. (See engine manual.)
or incorrectly gapped.
Water in fuel.
Drain fuel and refill with fresh fuel.
Circuit breaker blown.
See authorized service dealer.
Fuel mixture too rich.
Clean air filter. Check the choke.
Engine starts
hard or runs
Spark plug faulty, fouled, or
Clean and gap or replace. (See engine manual.)
poorly,
incorrectly gapped.
Fuel filter dirty.
Replace fuel filter.
Low oil level.
Check/add oil as required.
Engine knocks.
Using wrong grade oil.
See engine manual.
Engine running too hot.
See engine fins, blower screen, and air cleaner.
Excessive
oil
Using wrong grade oil.
See engine manual.
consumption.
Too much oil in crankcase.
Drain excess oil.
Dirty air filter.
Replace air filter. (See engine manual.)
Engine exhaust
is black.
Engine choke control is in
Open choke control.
closed position.
Engine runs, but rider will
Transmission(s) disengaged.
Unlock roll release rod(s).
not drive.
Belt is broken.
See authorized service dealer.
Drive belt slips.
See authorized service dealer.
Brake is not fully released.
See authorized service dealer.
Internal transmission
See authorized service dealer.
problem.
31
Need help?
Do you have a question about the ZTS 7000 and is the answer not in the manual?