Samsung LN-T4066F Owner's Instructions Manual page 82

Listening through a Receiver (Home theater)
You can listen to sound through a receiver insteadof the TV speaker
1. Press the Anynet+ button.
Press the • or • button to select Receiver, then press the ENTER button.
2. Press the ,_ or t_ button to select to On. then press the ENTER button
Now you can listen to sound through the receiver
3. Press the EXIT button to exit
> When the receiver isset to On, you can listen to the TV sound through the 2-channel receiver
If the receiver is exclusively for a home theater only (supporting audio only), it may not appear in the
device list.
Only when you have connected the optical jack of the TV and the receiver properly, does Receiver work
In case of a content with copyright problem, listeningthrough the receiver may not properly operate
Check Points before Requesting Service
Anynet+ does not work. • Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+
devices only.
• Connect only one receiver (home theater)
• Check if the Anynet+ device power cord is properly connected.
• Check the Anynet+ device's Video/AudioiHDMI 13 cable connections
• Check whether the TV remote control is in TV mode
• Check whether it is Anynet+ exclusive remote control.
• Anynet+ doesn't work at a certain condition (Searching channels, Operating
WiSELINK)
I want to start Anynet+. • Check if the Anynet+ device is properly connected to the TV and check if the Anynet+
(HDMi-CEC) is set to On in the Anynet+ Setup menu
• Press the TV button on the TV remote control to switch to TV Then press the
Anynet+ button to show the Anynet+ menu and select a menu you want
I want to exit Anynet+. • Select Watch TV in Anynet+ menu
• Press the SOURCE button on the TV remote control and select a device other than
Anynet+ devices
• Press CH, CH LIST, PRE-CH, etc to change to the TV mode (Note that the channel
button operates only when a tuner-embedded Anynet+ device is not connected.)
The Connecting to Anynet+ • You cannot use the remote control when you are configuring Anynet+ or switching to a
device.., message appears on the view mode.
screen. • Use the remote control when the Anynet+ setting or switching to view mode is
complete
The Anynet+ device does not play. You cannot use the p_ayfunction when an auto channel scan is in progress or in
WISELINK mode Stop the currently running function
The connected device is not • Check whether or not the device supports Anynet+ functions
displayed. • Check whether or not the HDMI t 3 cable is properly connected
• Check whether HDMI Control is set to On in the Anynet+ setup menu
• Search Anynet+ devices again.
• You can connect an Anynet+ device using the HDMI 1.3 cable only Some HDMI
cables may not support Anynet+ functions