Samsung LN-T4066F Owner's Instructions Manual page 14

Operation
Turning the TV On and Off
Press the POWERO button on the remote control
You can also use thed) button on the front of the pane_
Plug & Play Feature
When the TV is initially powered on, basic settings proceed autorqaticaily and subsequently:
1, Press the POWER button on the remote control.
The message "Menu language, Shop Mode, Channels and Time will be set._ is
displayed
Press the ENTER button, then "Select the language of the OSD" menu
is automatically displayed
2, Press the • or • buttons to select language, then press the ENTER button.
The message "Select Home Mode when instatlingthis TV at home" is displayed
3, Press the • or • buttons to select "Shop" or "Home", then
press the ENTER button
The message "Select the antennas to memorize" is displayed.
>-We recommend setting the TM to Home mode for the best picture in your
home environment
Shop mode is only intended for use in retail environments.
if the unit is accidentally set to Shop mode and you want to return to Dynamic
(Home) mode, press any Volume button and then hold down the MENU button
for five seconds on the side panel of the T\/.
4, Press the • or • buttons to memorize the channels of the selected connection
Press the ENTER button to select "Start"
>_If the antenna is connected to ANT t (AIR), select "Air" and if it is connected to
ANT 2 (CABLE), select "Cable"
If both ANT 1 (AIR) and ANT 2 (CABLE) are connected, select the "Air + Cable"
>_In Cable mode, you can select the correct signal source among STD, HRC,
and IRC by pressing the • or • button, then press the ENTER button
Contact your local cable company to identify the type of cable system that
exists in your particular area
5, The TV will begin memorizing atl of the available channels.
After all the available channels are stored, the Auto program menu reappears
Press the ENTER button when channel memorization is complete
The message "Select the clock mode" is displayed
>-To stop the search before it has finished, press the ENTER button with stop
selected
6, Pressthe ENTER button
Press the • or • buttons to select "Manual" or "Auto", then Press the
ENTER button
The message 'Set to daylight savings time" is displayed.