Samsung LN-T4066F Owner's Instructions Manual page 19

Setting Up Your Remote Control
After the television has been set up properly, your remote control can operate in five
different modes: TV, DVD, Cable, Set-Top Box, VCR. Pressing the corresponding buttonJ
on the remote control allows you to switch between these modes, and control
whichever piece of equipment you choose,
_*The remote control might not be compatible with all DVD Players. VCRs. Cable boxes, and
Bet-Top Boxes
Setting Up the Remote to Operate Your VCR
1. Turn off your VCR
2. Press the VCR button on your TV's remote control
3. Press the SET button on your TV's remote control.
4. Using the number buttons on your remote control, enter three digits of the VCR code
listed on page t9 of this manual for your brand of VCR Make sure you enter three digits [
of the code, even if the first digit is a "0"
(If more than one code is listed, try the first one.)
5. Press the POWER® button on the remote control.
Your VCR should turn on if your remote is set up correctly.
If your VCR does not turn on after set up, repeat steps 2, 3, and 4, but try one of the
other codes listed for your brand of VCR
if no other codes are listed,try each VCR code. 0O0 through 088.
_- Note on Using Remote Control Modes: VCR
When your remote control is in "VCR" mode. the volume buttons still control your
TM's volume.
@o,? @0
C_LI_T WlSELI_.K_EC
;DQO®
866
c:3 c:_sczs
Setting Up the Remote to Operate Your Cable Box [
1. Turn off your cable box _.) r_r_q_
2, Press the CABLE button on your TV's remote control. _1_
3, Press the SET button on your TV's remote control.
4. Using the number buttons on your remote control, enter three digits of the cable box codel _('_ ('_ (_
listed on page 20 of this manual for your brand of cable box. Make sure you enter three
thedigits of the code even if the first digd is a "O" (if there is more than one code listed, trYfirst one) I(_) _ (_)
5, Press the POWER_ button on the remote control. _("_'_ ('_ (_'_
Your cable box should turn on if your remote is set up correctly.
If your cable box does not turn on after set up repeat steps 2 3 and 4 but try one of theJ p
other codes listed for your brand of cable box If no other codes are listed, try each code, ,,_.._c_u, .,_u_K_Ec
0O0 through 046 L L'_ L'_ C) _ .
Note on Using Remote Control Modes: Cable Box
When your remote control is in "CABLE" mode, the volume buttons still control your
TV's volume.
dhc