Samsung LN-T4066F Owner's Instructions Manual page 80

Setting Up Anynet +
The following settings are to use Anynet + functions.
To use the Anvnet+ Function. HDMI Control must be set to On
1. Press the Anynet + button.
Press the • or • button to select Setup, then press the ENTER button
2. Press the ENTER button to select Anynet+ (HDM6CEC), then press the ENTER
button
3, Press the • or • button to select On, then press the ENTER button
The Anynet+ (HDMt-CEC) function is enabled
If you select Off, Anynet + (HDM6CEC) is disabled
Settino an Anvnet+ Device to turn Off Automatically when the TV is Turned Off
2. Press the • or • button to select Auto Turn Off, then press the ENTER button.
3. Press the • or • button to select On, then press the ENTER button
_" The Auto turn off function is enabled.
If you select Off, the Auto turn off function is canceled.
Press the EXIT button to exit.
;'-- The Select Device setting of the TV remote control is to be set to TV to use the
Anynet + function
If you set Auto Turn Qff to On, connected external devices are also turned off when the TV is turned off
However, if the device is recording, it may not be turned off
When the Anynet+ (HDM6OEC) function is disabled, all the Anynet + related operations are deactivated.
Scanning and Switching between Anynet+ Devices
1. Press the Anynet+ button.
+
Anynet devices connected with the TV are listed.
2,
3,
Press the • or • button to select to a particular device and press the ENTER button
It is switched to the selected device.
If you cannot find a device you want, press the • or • button to select Searching
Connections, then press the ENTER button.
The meassage Configuring Anynet+ connection is displayed
When searching devices completes, the connected devices are listed in the Anynet +
menu
Switching to the selected devices may take up to 2 minutes You cannot cancel the
operation during the switching operation
The time required to scan for devices is determined by the number of connected
devices.
When the device scan is complete, the number of found devices is not displayed.
Although the TV automatically scans devices when it is turned on using the POWER button, devices connected when the TV
is on or under a specific circumstance are not displayed in the device list. Therefore select Searching Connections menu to
search devices.
If you have selected external input mode by pressing the SOURCE button, you cannot use the Anynet+ function Make sure to
switch to an Anynet + device by using the Anynet + button.