Air Conditioner Remote Control; Cleaning The Air Filter - Fedders A6X05F2D Manual

Room air conditioners for double-hung windows
Table of Contents

Advertisement

Available languages

Available languages

Room Air Conditioner

Air Conditioner Remote Control

The functions work the same as your air conditioner's touch
controls.
CAUTION
• Use only AAA or IEC R03 1.5V batteries.
• Remove the batteries if the remote controller is not used for
a month or longer.
• Do not attempt to recharge the supplied batteries
• All batteries should be replaced at the same time.
• Do not dispose of the batteries in a fire as they may explode.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon - zinc), or
rechargeable (nickel-cadmium) batteries.
• Do not install the batteries with the polarity (+/–) reversed.
• Keep batteries and other things that could be swallowed
away from young children. Contact a doctor immediately
if an object is swallowed.
7
AAA
R03
IEC
1.5V
AAA
IEC R03
1.5V

Cleaning the Air Filter

Every two weeks: Clean the Filter
1. Turn power to OFF.
2. Remove the air filter by grasping the top corners and
pulling it up and out of the unit (Fig. 8).
3. Wash in hot soapy water, rinse and shake dry.
4. Replace the filter, with the front of the filter toward you.
5. To dry the filter thoroughly, run your unit for a few
minutes. Remember, only a clean filter works properly
and delivers top efficiency at every setting.
Proper use and care of your air conditioner will help ensure
longer life of the unit. It is recommended to have the unit
inspected annually, as well as having the coils and
condensate water passages cleaned. Expense of the annual
inspection is the consumers' responsibility.
10
8
Air Filter
AAA
R03
IEC
1.5V
AAA
IEC R03
1.5V
Note: Failure to keep air filter clean will result in poor air
circulation.
DO NOT operate without filter. This can render the unit
inoperable.
Decorative Front Removal
1. Turn the unit off and remove the plug from the outlet.
2. Remove the screws on either side of the cabinet (Fig. 9).
3. Gently pull forward while grasping both sides of the
decorative front.
4. To replace the decorative front, line up the top and
bottom and sides, and gently press into position.
5. Reattach the screws on both sides of the decorative front.
Make sure the decorative front is secure before
reconnecting the plug and operating the unit.
9
Remove screw
from both
sides of
cabinet
5
Decorative Front

Advertisement

Table of Contents
loading

Table of Contents