Timer Control - Fedders A6X05F2D Manual

Room Air Conditioner
ELECTRONIC CONTROL PANEL
6
B
F
D
A
A Power Control
Temperature/Timer Display
B
Temperature/Timer Controls
C
Mode Control
D
Fan Speed Control
E
Timer On/Off
F
Power Control
The Power Control turns the unit on and off.
The Temperature/Hour Display
Shows the set temperature or the timer setting. THE
TEMPERATURE DISPLAY ONLY SHOWS THE SET TEMPERATURE,
NOT THE ACTUAL ROOM TEMPERATURE.
Temperature/Hour Controls
These buttons are used to raise or lower the set
temperature in increments of 1° from 66° to 88°. They also
raise or lower the hour setting in increments of 1 from 00
to 24 when the timer is being set. In order to toggle
between °F or °C, depress both of the controls at the same
time.
Mode Control
The Mode Control has two settings: FAN and COOL.
The settings are adjusted with the Mode Control button. A
green light indicates which setting is currently being used.
When the COOL mode is selected, the unit will circulate
and cool the air.
If the FAN mode is selected, the unit will only circulate the
air.
C
E
Fan Speed Control
The Fan Speed Control has three
settings: High, Low and Auto. The settings are adjusted
with the Fan Speed button, each time the button is
depressed it changes the
setting. A green light will indicate which setting is
currently being used.
When the Auto feature is selected while the air
conditioner is in the COOL mode, the fan speeds will
change automatically as the temperature in the room
changes.
• 4° or more above the set temperature the unit will be in
HI FAN mode.
• 4° or less above the set temperature the unit will be in
LO FAN mode.

Timer Control

The timer can be set to either turn the unit on or off.
To turn the unit on using the Timer:
•Depress the timer key when the power is off, the display
will read 00. Adjust to the desired number of hours
before TURN ON using the up/down arrows.
•The display will show the time by hours left until TURN
ON.
•To Turn the timer off, depress the timer key.
•A green light next to the Timer Control indicates that the
timer is set.
To turn the unit OFF using the Timer:
•Depress the timer key when the power is on, the display will
read 00. Adjust to the desired number of hours before TURN
OFF using the up/down arrows. The display will automatically
go back to the set temperature after 10 seconds.
•To display the amount of time left until TURN OFF, depress the
timer button once.
•To turn the TIMER OFF, depress the timer button twice.
•A green light next to the Timer Control indicates that the timer
is set.
Built-in three minute timing delay.
If this electronic unit will not respond to touch pad or remote
control commands, it is necessary to unplug the unit from the
electrical outlet for five seconds and then plug the unit back in.
Auto restart feature:
In the event of a power failure, this feature allows the unit to
resume operation once power has been restored, retaining the
most recent settings. Upon restoration of power, the timer mode
may need to be reset if being utilized.
4