How To Use; Procedures; Power Supply - Epson SpectroProofer Mounter 17 User Manual

SpectroProofer Mounter 17"

How To Use

This product is an automated color measurement system that can be installed on the printer. For supported printers,
see the catalog or the printer's manual.
This section introduces color measurement procedures using the SpectroProofer Utilities found on the Software Disc
(SpectroProofer Software Disc) supplied with this product.
Note:
To use the SpectroProofer Utilities, you need to install the Epson printer driver on your computer in advance. You cannot use
this utility with printers that are not supported by the Epson printer driver.

Procedures

A
Confirming the printer setup
Make sure to complete the printer setup (setting up the printer and installing the printer driver). Turn on the printer and make
sure it is in the ready state.
B
Color calibration U See
Calibrate your printer using Printer Linearization in the SpectroProofer Utilities.
C
Color measurement U See
Select a job by starting Preparing and executing a color measurement job in the SpectroProofer Utilities.
When you start Job status confirmation on the SpectroProofer Utilities, you can check the status of the current job.
See the online help for details.

Power Supply

This product has no power button.
The power is on when you connect the printer connection cable and turn on the printer.
The power is off when you turn off the printer.
Caution:
c
When using this product, first connect the printer connection cable, and then turn on the printer. This product does not
work correctly if you connect the printer connection cable when the printer is on.
User's Guide
How To Use
"Color calibration" on page 11
"Preparing and executing a color measurement job" on page 12
8