Selecting The Pause For Low Ribbon Option - FARGO electronics S000256 User Manual

RESTRICTED USE ONLY

Selecting the Pause for Low Ribbon option

Use this option to generate a definitive warning when the print ribbon is running low. (Note:
When this option is selected, the Printer will beep, pause, and the Ready LED will flash when
approximately 10 to 20 prints remain on the print ribbon.)
Step Procedure
1 Replace the ribbon and press the Pause/Resume button to continue printing
with a new ribbon.
OR
Leave the existing ribbon in the Printer and press the Pause/Resume button.
•
Once the Pause/Resume button is pressed, the Printer will continue
printing until the end of the ribbon, but will beep once before each print job.
•
It will not be necessary to press the Pause/Resume button again to
continue printing once it has been pressed initially during a batch print.)
•
The Printer will still beep once before each print job when approximately 10
to 20 prints remain on the print ribbon; however, the Printer will not pause.
Instead, it will continue printing until the end of the ribbon, without User
intervention.
Persona® C25 Card Printer User Guide (Rev. 4.0)
FARGO Electronics, Inc.
98