Converged Network Adapters; Pci Express Interface - Dell Brocade Adapters Installation And Reference Manual

TABLE 17
Property
Power Consumption
adapter and optics
Operating Voltage

Converged Network Adapters

Two types of CNAs are available:
The Brocade stand-up CNAs are low-profile MD2 form factor PCI Express (PCIe) cards, measuring
6.60 in. by 2.71 in. (16.77 cm by 6.89 cm). CNAs are shipped with a low-profile bracket installed
and a standard bracket included for mounting in your host system.
types and dimensions.
TABLE 18
Bracket Type
Low Profile
Standard
Mezzanine CNAs are smaller than stand-up modules. For example, the Brocade 1007 adapter is an
IBM compact form factor horizontal (CFFh) adapter measuring approximately 4.9 in. (12.44 cm) by
0.5 in. (1.27 cm) by 6.3 in. (16 cm). Mezzanine adapters mount on blade servers that install in
supported blade system enclosures. Refer to the
(mezzanine adapters)"
mezzanine CNAs do not have external port connectors with optics such as stand-up CNAs, but
internal ports that connect to switch and I/O modules installed in the blade system enclosure
through high-speed links in the internal enclosure backplane.

PCI Express interface

Install Brocade stand-up CNAs in PCI Express (PCIe) computer systems with an Industry Standard
Architecture/Extended Industry Standard Architecture (ISA/EISA) bracket type. Install the Brocade
mezzanine CNAs in supported server blades that install in supported blade system enclosures.
On-board flash memory provides BIOS support over the PCIe bus.
The CNA is designed to operate on an x8 lane DMA bus master at 250 GMhz. Operation can
negotiate from x8 to x4, x2, and x1 lanes. Following are transfer and data rate specifications for
operation in PCIe Gen 2 and Gen 1 connectors:
•
•
Brocade Adapters Installation and Reference Manual
53-1002144-01
Environmental and power requirements (continued)
•
Stand-up adapter
•
Mezzanine adapter
CNA mounting brackets
Dimensions
73 in. by 3.15 in. (1.84 cm by 8.01 cm)
73 in. by 3.15 in. (1.84 cm by 12.08 cm)
on page 11 for references to CNA compatibility information. Note that
PCIe Gen 2 connector. Transfer rate of 5 Gigatransfers per second (GT/s) per lane. Data rate of
500 MBps per lane.
PCIe Gen 1 connector. Transfer rate of 2.5 GT/s per lane. Data rate of 250 MBps per lane.
Converged Network Adapters
Requirement
9 W typical with SFP running 16 Gbps traffic
12V
"Server blades and blade system enclosures
Table 18 lists the two bracket
5
179