Dell Brocade Adapters Installation And Reference Manual page 95

•
•
•
•
•
•
•
•
Brocade Adapters Installation and Reference Manual
53-1002144-01
You must use the Brocade Adapter Software Installer application to install HCM to the host
system where the adapter is installed or to a separate remote management platform.You
cannot install HCM using the Brocade-provided installation scripts or your system's "native"
installation commands. After installation, an HCM desktop shortcut is available on Windows
and Linux systems.
Ensure that Visual Studio 2005 SP1 (or later) Redistributable package is installed on Windows
2003 R2 SP3 systems to avoid problems starting HCM Agent.
There are firewall issues with HCM Agent on Windows 2008 and VMware systems. When
installing the driver package on these systems, open TCP/IP port 34568 to allow agent
communication with HCM.
-
For VMware, use the following command to open port 34568:
/usr/sbin/cfg-firewall -o 34568,tcp,in,https
/usr/sbin/cfg-firewall -o 34568,udp,out,https
-
For Windows, use Windows Firewall and Advanced Service (WFAS) to open port 34568.
Note that you can change the default communication port (34568) for the agent using the
procedures under "HCM Agent operations"
On Linux SLES 10 and 11 systems when installing the source-based (noarch) driver packages
(brocade_driver_linux_<version>.tar.gz) or when using the Brocade Adapter Software Installer
and the kernel has been upgraded to a version without pre-compiled binaries, perform the
following tasks to make sure the drivers will load on system reboot:
-
For Linux SLES 10 systems, make sure that the LOAD_
UNSUPPORTED_MODULES_AUTOMATICALLY variable on your system is set to "yes." This
variable is in the following configuration file.
/etc/sysconfig/hardware/config
-
For Linux SLES 11, change the "allow_unsupported_modules" value from 0 to 1 in the
following file.
/etc/modprobe.d/unsupported-modules
Only one driver installation is required for all Brocade adapters (HBAs, CNAs, or Fabric
Adapters) installed in a host system.
Root or administrator privileges are required for installing the driver package.
The procedures in this section assume that the host's operating system has been installed and
is functioning normally.
Before installing the driver on Windows systems, install the following hot fixes from the
Microsoft "Help and Support" website, then reboot the system:
-
Windows 2003
KB932755 (or later) is the minimum requirement.
KB943545 is recommended if the HP command view management application is used to
manage HP EVA arrays in the target system.
-
Windows 2008
KB968675 is recommended. This fixes a non-paged memory leak in a Windows 2008 storage
stack.
KB2490742 is recommended when installing storage drivers to avoid a "Ox000000B8" stop
error when shutting down or hibernating a system running Windows 7 or Windows Server 2008
R2.
Installation notes
on page 112.
3
67