Installing Snmp Subagent - Dell Brocade Adapters Installation And Reference Manual

•
•
•
•

Installing SNMP subagent

Simple Network Management Protocol (SNMP) is supported by CNAs and by Fabric Adapters for
ports configured in CNA or NIC mode. For more information, refer to
Protocol"
master agent, called the subagent, which processes SNMP queries for Brocade adapters. The
subagent is only supported on Linux and Windows systems. SNMP subagent files are copied to
your host system when you install adapter management utilities through HCM and the Brocade
Adapter Software Installer (BASI).
Brocade Adapters Installation and Reference Manual
53-1002144-01
Make sure that all Fibre Channel devices connected through the adapter and associated FCoE
or Fibre Channel switch are correctly connected, powered up, and operating correctly. If not
powered up, devices will be unavailable.
Verify host system storage, switch, and operating system compatibility using the
interoperability matrices on the Brocade adapters website at
Verify the following for stand-up adapters only:
-
Observe LED operation on adapter and refer to the
for Fabric Adapters, "Adapter LED operation (stand-up adapters)"
and "Adapter LED operation (stand-up adapters)"
through the adapter's mounting bracket.
If LEDs indicate that the link between the adapter and switch is not operational, this could
mean that a problem on the link between the switch and adapter or that the driver is not
loaded and communicating with the switch.
-
The adapter is installed in the appropriate connector in the host system.
-
All small form factor pluggable (SFP) optic receivers are correctly installed, seated, and
latched in adapter SFP receiver slots.
-
Cables are properly connected to the appropriate adapter port and seated in the SFP
connector.
-
Correct options are configured for the slot where the adapter is installed,
Verify the following for mezzanine adapters only:
-
The blade server or server blade is turned on.
-
The adapter is installed in the appropriate connector. On some blade servers or server
blades, connectors may only support a specific adapter type. Refer to your blade sever
documentation for help.
-
Whether the blade server or server blade on which the adapter is installed is correctly
configured and installed in the blade system enclosure. Refer to your blade server and
blade system enclosure documentation for help.
-
Any modules or blades in that support adapter operation are installed in the appropriate
enclosure bays and correctly configured. Refer to the documentation for your blade system
enclosure for help.
-
The blade system enclosure is configured for adapter operation. Refer to your blade
system enclosure and documentation for blade system enclosure components for help.
-
You are using the latest device drivers, firmware, and BIOS for the blade server (or server
blade) and other components in the blade system enclosure that support adapter
operation.
on page 34. Brocade adapter SNMP is supported through an extension to the SNMP
Installing SNMP subagent
www.brocade.com/adapters
"Adapter LED operation"
on page 191 for CNAs,
on page 184 for HBAs. LEDs are visible
"Simple Network Management
3
.
on page 177
109