Configuring Network Boot - Dell Brocade Adapters Installation And Reference Manual

•
•
•

Configuring network boot

Configure Network Boot on the adapter using the Brocade PXE BIOS Configuration Utility, BCU
commands, and HCM.
Configuring PXE BIOS using the Brocade Configuration Utility
Use the following procedures to configure network boot using the PXE PXE BIOS Configuration
Menu.
1. Power on the host system.
2. Watch the screen as the system boots. When "Brocade PXE 2.1 BIOS 2010-11 All rights
[
Brocade Adapters Installation and Reference Manual
53-1002144-01
Linux (RHEL)
For supported versions later than RHEL 4.9, "nw" drivers support network (PXE) boot. Install
these drivers after fc drivers. For RHEL 4.9, network drives are part of a single ISO package.
Linux (SLES)
Network drivers are part of a single ISO package.
VMware ESX
Network boot is currently not supported.
reserved" displays, press Alt+B or Ctrl+B.
The Brocade PXE BIOS Configuration Menu displays a list of installed adapter ports, similar to
the following.
Under the Ad No column, 1/0 and 1/1 are the first port and second port respectively on the
first installed adapter while 2/0 and 2/1 are the first and second port on the second installed
adapter.
The Configuration Utility supports a maximum of 16 ports, and 8 ports can display on a screen
at a time. Select Page Up to go to a previous screen or Page Down to go to the next screen.
4
Network boot
123