Elo TouchSystems M-Series User Manual page 35

and interconnecting cabling provided with the equipment. Substitution of
provided cords and cabling may compromise electrical safety or CE Mark
Certification for emissions or immunity as required by the following
standards:
This Electronic Equipment is required to have a CE Mark on the
manufacturer's label which means that the equipment has been tested to
the following Directives and Standards: This equipment has been tested
to the requirements for the CE Mark as required by EMC 2004/108/EC
and LVD 2006/95/EC indicated in European Standards EN55022,
EN55024, and EN60950-1, as well as these standards for medical
electrical equipment. EN 60601-1 and EN60601-1-2 (including EN55011
Class A).
D) General Information to all Users: This equipment generates, uses and can
radiate radio frequency energy. If not installed and used according to this
manual the equipment may cause interference with radio and television
communications. There is, however, no guarantee that interference will
not occur in any particular installation due to site-specific factors.
1) In order to meet emission and immunity requirements, the user must
observe the following:
a) Use only the provided I/O cables to connect this digital device
with any computer.
b) To ensure compliance, use only the provided manufacturer's
approved line cord.
c) The user is cautioned that changes or modifications to the
equipment not expressly approved by the party responsible for
compliance could void the user's authority to operate the
equipment.
2) If this equipment appears to cause interference with radio or television
reception, or any other device:
a) Verify as an emission source by turning the equipment off and on.
b) If you determine that this equipment is causing the interference, try
to correct the interference by using one or more of the following
measures:
i) Move the digital device away from the affected receiver.
ii) Reposition (turn) the digital device with respect to the affected
receiver. iii) Plug the digital device into a different AC outlet so
the digital device and the receiver are on different branch
circuits.
iv) Disconnect and remove any I/O cables that the digital device
does not use. (Unterminated I/O cables are a potential
M-Series Touchcomputer User Guide 20