Table of Contents
Advertisement
The Menu System
The Multi-Screen
Feature
The Multi-Screen
feature is used to show either a single picture or two pictures on the screen at the same time. One of the pictures
must be from the RGB input.
SINGLE - Displays a single picture on the screen.
SIDE BY SIDE - Displays two pictures from different
input signals side-by-side.
PICTURE IN PICTURE - Displays two pictures from different
input signals; one fills the screen and one appears in a window on top of
the other picture.
Side-By-Side
iiii iiiiiiiiiiiiiiiii
ii
iEr0T oq ¸
1
_!`_ii_iiii_iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii_
Side-by-side 1: VIDE01
is the active picture.
Picture-in-Picture
rVI_DEO2 ]
i iiii
ii _
main
screen
Hetureqn-pieture
(window
on the left):
VIDE01 is the active
picture.
Side-by-side
2:VIDE01
is the active
picture.
r VIDEO2
]
mainscreen
Piet ureqn-piet
ure
(window
on the right}:
VIDE01 is the active
picture.
f
iii!i_ii:!_iiiiiiiiii::ii_i_!:_iiii;::!_i
¸ii;::!_i
¸ii;::!_i
¸ii;::!_i
¸ii;::!_i
¸ii;::!_i
¸ii;::!_i
¸ii;::!_i
¸ii;::!_i
¸ii;::!_i
¸ii;::!_i
¸ii;::!_i
¸ii;::!_i
¸ii;::!_i
¸ii;::!_i
¸ii;::!_i
¸ii;::!_i
¸ii;::!_i
¸ii;::!_i
¸ii;::!_i
¸ii;::!_i
¸ii;::!
The top screen shows VIDE01 as the active picture.
The bottom
screen shows VIDE02 as the active
picture.
To use the Multi-Screen feature:
1. Press the WHO,MULTIbutton on the remote to select a mode.
2. If side-by-side mode or picture-in-picture
mode has been selected, use the
left/right arrow buttons to position the subscreen as shown below.
3. The active picture (indicated in the above illustrations by the double box) is
the picture that is affected be remote actions and menu selections. To
switch the active picture, press the OK button. Press the OK button again to
change back to the other picture.
Note:Changing theactivepicturedoesn't c hangethesize or locationof thepictures.
Selecting the Input Signals to be displayed
To change the input signals displayed in multisereen operations:
1. Pressthe MULTI button to activate the Multisereen function. Pressthe OK
button to make the desired picture active.
2. Pressthe RGB,VIDEOor CMPNTbutton to change the input signal. The
INPUTeGO BACKbutton on the front of the monitor can also be usedto
changeinput selection.
18
Chapter 2
Advertisement
Table of Contents
