Table of Contents
Advertisement
The Menu System
Adjusting
the Picture
Settings
in MEMORY
Mode
In MEMORY mode, you can set and save the following
picture adjustments:
CONTRAST - Changes the picture's contrast (between light and dark).
BLACK LEVEL- Makes the picture lighter or darken
SHARPNESS - Changes the picture's sharpness.
COLOR - Changes color density (video input only).
TINT - Changes picture tint (video input only).
COLOR TEMP - Changes the color tone.
NOISE REDUCE- (noise reduction)-
Removes extraneous information
from the signal to make the picture
clearen
NOTE: O nlythe contrast andbrightnesscan be adjustedwhen a computersignal is used.
Once you have selected MEMORY mode, you can adjust the picture settings. For example, to change the
contrast setting:
This is the PICTURE QUALITYmenu with the PRESETS
option highlighted.
1. Use the • or •
button to highlight the CONTRASToption. Pressthe •
button to select it. The CONTRASTwindow appears. Use •
and •
buttons
to adjust the contrast.
NOTE: If you don't push the • or • button within 5 seconds, the
current setting is accepted and the previous screen reappears.
2. Oncethe contrast is adjusted, pressOK or MENU.Thecontrast is set and you
are returned to the PICTURE OUALITY menu.
3. Use the same procedure to adjust the black level and sharpness settings.
4. When you arc finished adjusting the picture settings, pressGO BACK to
return to the main menu or press CLEAR to exit the menu system.
If the "CONTROL NOT AVAILABLE" message appears when you arc trying to
change the picture settings, make sure the preset mode is set to MEMORY. You
can only change picture settings in MEMORY mode. The other modes are pre-
set and can't be changed.
This is the CONTRAST screen.
20
Chapter 2
Advertisement
Table of Contents
