Warnings And Safety Precautions; Important Tips: Caring For Your Monitor - RCA Scenium PHD50400 User Manual

Safety information
RISK OF ELI_(7*RIC St lOCK
DO NOT OPEN
TO REDUCE THE RISK OF ELECTRICSHOCK, DO NOT REMOVE
COVER (OR BACK). NO USER SERVICEABLEPARTS INSIDE.
REFERSERVICING TO QUALIFIED SERVICE PERSONNEL.
A
This symbol indicates "dangerous at
voltage" inside the product that
presents a risk of electric shock or
personal injury.
This symbol indicates important
instructions accompanying the
product.
Precautions
Please mad this manual carefully before using your Monitor and keep
the manual handy For Future reference.
WARNING
TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE
THIS UNIT TO RAIN OR MOISTURE. ALSO DO NOT USE
THIS UNIT'S PLUG WITH AN EX'ITNSION CORD
RECEPTACLEOR OTHER OUTLETS, UNLESS ALLPRONGS
CAN BE FULLYINSERTED. REFRAIN FROM OPENING THE
CABINET AS THERE ARE HIGH-VOLTAGE COMPONENTS
INSIDE. REFER SERVICINGTO QUALIFIED SERVICE
PERSONNEL.
Industry CanadaCompliance Notice
This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
Declaration of Conformity
This device complies with Part 15 of the FCC rules. Operation is
subject to the Following two conditions: (1} This device may not
cause harmful interference, and {2} this device must accept any
interference received, including interference that may cause undesired
operation.
Product: Cinema Screen Display
Equipment Classification: Class B Computer Peripheral
Model: PHDS0400
We hereby declare that the equipment specified above con|brms to
the technical standards as specified in the FCC rules.
Thomson multimedia Inc.
10330 N. Meridian St.
Indianapolis, 1N 46290
Phone: I-8OO-433-8974
Fee Information
* FCC Regulations state that unauthorized changes or modifications
to this equipment may void the user's authority to operate it.
• This equipment has been type tested and Found to comply with
the limits [or a Class B Digital Device in accordance with the
specifications in Part 15 of the FCC rules. These rules are designed
to provide reasonable protection against radio and television
interference in a residential installation. This equipment generates
and can radiate radio frequency and, if not installed and used in
accordance with the instructions, may cause harm|hl inter|_'rence
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause interference to the radio or television
reception {which you can determine by turning the equipment off
and on), try to correct the inter|_rence by one or more of the
Following measures:
• Reorient or relocate the receiving antenna {that is, the antenna [or
the radio or television that is "receiving" the interference}.
• Change the position of the monitor with respect to the radio or
television equipment that is receiving the interference.
• Move the monitor away From the equipment receiving the
interference.
Plug the monitor into a different wall outlet so the receiver and
the equipment are on different branch circuits.
1f these measures do not eliminate interference, please consult
your dealer or an experienced radio/television technician [or
additional suggestions. Also, the Federal Communications
Commission has prepared a helpful booklet, "How to Identify and
Resolve Radio/TV Inter|_rence Problems." This booklet is available
From the U.S. Government Printing Office, Washington D.C.,
20402. Please specify stock number 004-000-00345-4 when
ordering copies.
Cable TV Installer: This reminder is provided to call your attention to
Article 820-40 of the National Electrical Code {Section54 of the
Canadian Electrical Code, Part I) which provides guidelines Forproper
grounding and, in particular, specifies that the cable ground shall be
connected to the grounding system of the building as close to the
point of cable entry as practical.