Connectingother Antennas - Mitsubishi HS-U410 Owner's Manual

E> Important:
O Connect the fourth coaxial cable to the "OUT" terminal on the
A!B switch. Connect the other end of this (:able to the "}_N-
TENNA IN" terminal on your VCR.
O When you are finished, go to page 15, "Coilnecting the Televi-
sion."
With this connection, you should set the AfB switch to "B" only
when you are recording a scrambled channel, in that case, you
should set your VCR to record channel 3 (or 4), and manually set
the cable box to the channel you wish to record.
You should leave the A/B switch set to "A" for all other situations.
If you have questions concerning your cable system, please "
contact your cable company.
With this connection, you canr ot record a scrambled channel and
watch a non-scrambled channel at the same time. You also cannot
watch a scrambled channel an,:l record a non-scrambled channel
at the same time.
Connectingother antennas
If you don't have cable TV, you'll need to connect a regular an-
tenna. Your antenna may haw_ one of two different kind of,ends
(called "leads") on it.
The two kinds of leads are:
• 300-ohm flat twin leads that look like this:
• or a 75-ohm round lead that looks like [his:
Follow the procedures fbr connecting the kind of leads your
antenna has, then go to page 15, "Connecting the Television."
connecting an antenna witha 300-ohm flat twinlead
(If you have a 300-ohm flat twin lead, you will need to purc]hase a
300-75 ohm adapter at your local hardware or electronics store.)
O
O
Disconnect the antenna from the back of the TV.
Before you can attach the antenna leads to the adapter., you
need to expose a 5/8 inch segment of each lead by scraping off
the brown plastic covering. Sometimes tlhese leads haw,. "U"
shaped clips that fit around the screw, in which case you will
not need to peel back the plastic.
13